Setting the Light Color

Your LED uplight rental is packed with powerful options for setting colors to match your event decor. You have several options for selecting the color of the up light fixture:

  1. Static Color Mode – This option allows you to choose from 7 pre installed colors built into the up light fixture. The quickest and easiest way to set you lighting color.
  2. Custom Color Mode – This option allows you to set a custom static color based on adjustments of each of the primary (RGB) colored LED lights. This allows for precise color matching. See the “Custom Color Guide” for help finding the right settings for event!
  3. Digital Control Mode – Available with custom packages and upgrades, use the digital DMX controller to link the up lights together and change all fixtures at the same time with the press of a button. Additionally, you can use the sliding levers on the controller to adjust each primary color. This allows for easy and precise color matching to your event decor. The best part…you can change the lights throughout your event!

 

We highly recommend setting your colors before your event or at a minimum familiarizing yourself with the up light operation.

Static Color Mode

To enable the Static mode, do the following:

1)Connect each light to a suitable power outlet or chain light power

2)Light will turn on

3)Press <MENU>repeatedly until C– shows on the display.

4)Press <ENTER>

5)Use <UP> or <DOWN> to select the preset color: C1~C7

6)Press <ENTER>

7)Repeat steps on each up light fixture.

Custom Static Colors Mode:

1)Connect each light to a suitable power outlet or chain light power

2)Light will turn on

3)Press <MENU> repeatedly until U– shows on the display.

4)Press <ENTER>

5)Use <UP> or <DOWN> to select the desired color: red (r–) , green (g–) , or blue (b–)

6)Press <ENTER>

7)Use <UP> or <DOWN> to select the desired color value: 000~100

Selecting 000 will turn the color off

8)Press <ENTER> to continue to the next color

9) Repeat steps 5 ~ 7 until you create your desired color

10) Press <ENTER> to save the color

11)Repeat steps on each up light fixture.

 

DMX Controller Mode

To control light using the DMX panel, do the following:

1)Connect each light to a suitable power outlet or chain lights together. Connect DMX cables starting at the controller and working through entire line of lights you desire to be controlled by the DMX control panel.

2)Plug in and turn DMX control panel on. Power button located on back of controller.

3)On each uplight, Press <MENU>repeatedly until 3CH– shows on the display.

4)Press <ENTER>

5)Use <UP> or <DOWN> until units reads d001

6)Press <ENTER>

7)Repeat steps 3~ 6 on each up light fixture.

8)To use one of the pre-set colors, slide the right 2 toggle slider all the way to the top and the left most toggle slider all the way down. Press the “Preset” button on the left lower portion of the controller. Finally, press the desired pre-programmed color button on the left of the panel.

9)To create a custom color, press the “Manual RGB” button on the right side of the controller. Use the 3 sliders to increase and decrease the amount of Red, Green and Blue to create the desired effect.

*When switching between modes, it may be necessary to turn the controller off momentarily to reset the system.

UplightRental.com
Hampton, VA 23669
(757)637-0054
Website: http://www.uplightrental.com
Email: uplightrental@gmail.com